GSV RSV Fan Identification
ENERVEX EXHAUSTO exodraft GSV RSV Fan Identification
ID an ENERVEX fan by the first 6 alpha-numeric digits located on the tag.
IE… This fan is an ENERVEX GSV012 or GSV 12.
Below are Fan Housing Specs to ID GSV and RSV Fans
Use the parts tab to find the correct replacement parts page once you ID your fan.
GSV RSV Fan Identification
with no tag or ID Plate
The ID tag, usually located on the top plate for GSV/RSV fans, can become illegible from age or after a high heat event.
To determine the correct ENERVEX fan model and size… confirm if it has an axial vane or backward curved impeller… and reference a few housing measurements against an ENERVEX fan spec chart.
This fan was off a pizza oven from a restaurant.
***** Commercial kitchen would require a GSV series fan.
***** Axial vane would narrow it to 1 of 4 fans… GSV009 thru GSV016.
***** 15″ measured off the housing makes this a GSV012
The clam shell measurement of about 15″ was used against the fan model chart located below
B x B chart measurement of 15.37″ for an AXIAL VANE fan confirmed this to be a GSV012
Click here to reference ENERVEX replacement motor, wheel and available part numbers for RSV & GSV 009-016 Fans.
RSV/GSV 009 – 012 – 014 – 016
GSV 200 – 250 – 315 – 400 – 450
Backward Curved Impeller
RSV Fan Housing Specs
Find RSV 200-450 Fan Parts
RSV 200 – 250 – 315 – 400 – 450
Is it a GSV315 or an RSV315?
Before 2009 ENERVEX ( EXHAUSTO / exodraft ) upgraded the V4 Motors from a 17mm ( 1/2″ ) Shaft to a 19mm ( 3/4 ) Shaft…
If you are replacing an older 17mm V4 Motor you may also need to replace the Axial Vane or Impeller
The 1200795 V4 Motor is used for both GSV315 and RSV315… but use different Impellers
GSV 315 IMPELLER
633.0800.0010
INLET SIDE ID 11 1/4″
INLET COLLAR OD 12 3/8″
OAD 15 3/8″
RSV 315 IMPELLER
605.0800.0010
INLET SIDE ID 9 3/4″
INLET COLLAR OD 11″
OAD 15 3/8″
If the ID tag on the fan housing is unreadable or missing… how do I know if its an RSV315 or GSV315?
Measure the Impeller Seat and the Fan Housing.
The Impeller Seat for the RSV315 is removable and replaceable… In Stock.
The Impeller Seat for the GSV315 is part of the lower housing and not removable..
ME# 1200795 V4 Motor
650.0503.1200
RSV 315 Impeller Seat
605.0800.0007
The spinny thing ain’t an impeller?
If the V4 Motor is driving an Axial Vane.. the fan model should be the GSV16 or RSV16.
The GSV016 and RSV016 use the same Housing, Axial Vane, Cooling Vane and Inlet for Axial Vane.
Same Motor but the replacement parts will be…
Axial Vane
14″ OD
Inlet for Axial Vane
14 1/4″ ID
Cooling Vane
15″ OD
Call or e-mail for IN STOCK pricing. Expedited shipping available.